Birdman
09-13-2006, 08:23 PM
Completed the installation of All Balls Steering Head Bearings #22-1020. Major improvement, the only test so far is the driveway 100+ft of gravel, some local 2 lane and a short bast on the x-way. Well worth the effort to replace the old ball bearing.
The only difficulty was removing the old lower inside race. Need to heat the race and then place the tube in ice water. This helps but it's still a job that goes better if you have a large vise.
No picture - sorry I never think about it as I am working.
The only difficulty was removing the old lower inside race. Need to heat the race and then place the tube in ice water. This helps but it's still a job that goes better if you have a large vise.
No picture - sorry I never think about it as I am working.