RECALLS...what and how??

[VINCEFLCBX]

Hi guys....I have a question about RECALLS. I have an 04 ST with 21k miles. Used new to me...How do I find out what the recalls have been and how do I find out if mine has had the recalls performed??? ThX in advance for any asistance.!!:confused: :04biker:

[sherob]

Take your VIN to a dealer and they can look it up for ya :)

[Blrfl]

Have a look here (http://stwiki.notonthe.net/twiki/bin/view/ST13/ModelYearChanges) for recalls by year. PDFs with instructions are attached to the two for your '04 and will show where the punch marks go on the VIN label for each one.

--Mark

[VINCEFLCBX]

ThX guys!!!!!!!!!!!!!!!!!!!!!!!

[jasonJonas]

2007...Better seal between the saddle and the tank (unconfirmed)

i can confirm that that is not true. picked up my 07 this past saturday and the fit/finish between the tank and the sides of the seat is way off. it's the first thing i noticed when i picked up the bike. i thought they didn't put the seat on correctly. surprising. the fit/finish on everything else is great.

[Blrfl]

You sure it's not just a function of where you have the adjuster set? On mine, the seat looks great in one position but a little out-of-place in the other two.

--Mark

[jasonJonas]

when i picked up the bike, the seat was on its lowest setting. yesterday i set it to the middle position. i haven't tried the upper position yet. seems the higher it goes, the less likely the plastic groove on each side will line up with the notch-thingy-ma-jig. i'll take a look at it this evening.

[GPT]

The seat on my '07 is the same. It has two loose "flaps" in the front, strange.

[DavidM]

Had an uncomfortable couple of hundred kilometer on my new 07. Also noted that the front part of the seat just didn't seem to fit correctly to the tank. A closer look showed the front was set to the lowest position but the back was positioned in the middle slot. It took a bit of an off center push to get the back positioned into the lowest slot. Improved the comfort and the appearance.