Question on getting plugs for quartet harness

[dannyk]

When the bike arrives I will need to install some electrical components, cb heated grips etc. I am wondering where can you get the plugs that plug into the harness and the pins to go along with them, tried the local auto parts store, had the quartet harness with me for him to look at, looked at me like a cow looking at a new gate. any suggestions?

[STCPO]

Give these guys a call. They have everything you need to build a custom harness that will plug directly into the Honda harness.

2 Wheel Innovations (http://www.2wheelinnovations.com/connectors1.htm)

Pete :04biker:

[crazykz]

Hi Danny,

I believe these are the ones others have pointed me to at 2wheelinnovations.com.

Connectors (http://www.2wheelinnovations.com/Honda_bikes.htm)

Someone can correct me if I'm wrong.

Curt

[NormanPCN]

You can get them at California Sport Touring (http://www.casporttouring.com/store/merchant.mvc?Screen=CTGY&Category_Code=El)

[Kennedy]

Electrical connection has them also. Can't verify the fit yet because still waiting for them to get here. :confused:
http://www.electricalconnection.com/electrical-components/hitachi.htm

[dannyk]

Kennedy how long ago did you order them?

[dannyk]

Thanks guys, got them on the way

[Kennedy]

Not sure what is going on over there. I ordered them on line on Feb 3 and checked my order last week just to confirm all was well. Never got shipped until Feb 15 so they should come this week.

[dannyk]

My intention is to power the GPS, heated hand grips, and CB radio from this harness. Heated jacket liner will come directly off of the battery.

[crazykz]

Speaking of the quartet harness does anyone have the pinouts for the connectors as what each wire on the connectors does?

I would like to hook up all my farkles off of their also but I haven't figured out what's what on the harness. I already have the heated grips and 12V socket running off of their, I think.

Curt

[Kennedy]

Don't get me wrong here fellows but I think, maybe, guessing there might be an error in some of them. So if I am wrong will stand corrected and apologise.
As I said I haven't opened mine up yet but this would make the 12 volt outlet powered only in the acc position. Mine was done by Honda and it is powered in the run position.
Hondaline Power Outlet Connector
Red 3-pin connector:
Green=Ground,
Lt_green/black=12V on Acc only


I am hopeing this one is true "White/Green is hot when the brake light is on." If some one can tell me where I am going wrong on this on please let me know because I would like to make use of this wire but after traceing the electrical drawings through I have come to the conclusion W/G is the hot side of the brake light switches which will change to Y/G on the cold side. W/G is feed from fuse #3 and also powers the horn and the hi/lo beam relay. So I my self can not figure out how its hot when the brake switches are on. And once again sorry if I am in error here.