Its starting to get cold up here, so my first purchase for the new bike was heated grips. (necessity up here) I bought a set of Oxford Hot Grips ($80.cdn versus $350. for the OEM Honda grips) Not sure how good they are and I can still take them back if they're junk. Although the Honda grips would likely look better, install easier and work better, I need to save some $$ for some ergonomic upgrades. (Helirisers, Utopia back rest etc). Can someone please tell me where I can connect the wiring for the grips? Although wiring directly to the battery terminals would be the easiest by far, its a bad idea for someone as forgetful as me - for obvious reasons. I've read about references to a Quad harness - is this a Honda part? Even so, where do you tie in the harness? I've found the fuse blocks on the left side of the bike, and am thinking that would be a likely spot to tie in. Any guidance from the experienced members would be greatly appreciated. ps. I also have a Stebel horn that I'd like to hook up as well so that I can get the attention of jack ___ talking on their cell phones while driving.
Best Regards,
Best Regards,