Gerbing Dual Temp-Controller lights?

Joined
May 7, 2007
Messages
156
Location
San Jose, CA
Bike
2005 ST1300A
STOC #
889
I just got a Gerbing jacket liner, gloves and Portable Dual Temp-Controller. Wonderful this morning at 37 degress. Works great. Plugged into the Powerlet outlet I installed under the seat. What I did not see in the instructions is the meaning of the lights on the controller. Green, Yellow, red, blinking or steady. What's it mean?
 
Joined
Apr 25, 2007
Messages
4,954
Age
62
Location
New Jersey
Bike
st1300 '04
STOC #
7163
I have the Powerlet version assuming this is a rebranded gerbing.
Color is which channel on the 2 channel version.
Blinking is the on part of the duty cycle of the controller as you adjust it.
 
Joined
Feb 21, 2007
Messages
527
Location
Warrenton, Va
Bike
07 ST1300A
My dual temp controller only has 2 leds, each a diff color for that control. As mentioned, the frequency of led flashed corresponds to the duty cycle. You can always call Gerbing if you need more info, they're pretty responsive.
 
Joined
Feb 13, 2008
Messages
9
Location
Waukesha, WI
I have the Powerlet version assuming this is a rebranded gerbing.
Color is which channel on the 2 channel version.
Blinking is the on part of the duty cycle of the controller as you adjust it.
Actually the Powerlet is a rebranded Warm N Safe.

You are correct about the duty cycle of the controller. Basically the light indicates when the power is being passed to the liner. The longer the light is on/more flashes, the higher frequently the liner gets power to it, thus causing the higher temp.
 
Top Bottom