PDA

View Full Version : CreSTOC: Autocad help?

dmulk
02-24-2008, 02:00 PM
This is a weird request.... but if I can get these done soon enough, I could potentially have the work done on my place to allow more tent space. :)

I want to add 2 ~16 X 35 foot decks and a 20X20 deck to my house.... this would allow some folks to setup their tents and stay at my place... :)

Anyway, last year I paid a "friend" of mine that was in financial straights quite a bit of money to do these plans.... he basically gave me a draft and then fell off the face of the planet...

So....I am still looking for someone to translate the deck addition plans into an Autocad format...

You can find the plans here if you have experience and want to help... :)

http://www.dmulk.com/plans/

These PDFs reflect a room addition on an unbuilt level of the house.... that doesn't need to be translated....( Don't have the money for it...) only the deck portions....

I need to get these into autocad so I can send them to an engineer to do the load calculation for the permits... :/

If you have question, you can PM me or email me here: dmulk@yahoo.com
Cheers!

<D>
dteel
02-25-2008, 03:13 PM
Dan, I wish I had the AutoCAD expertise to help. Unfortunately, I do not. I suspect that you will end up paying someone to do the work again.

Best of luck finding help.
dmulk
02-25-2008, 06:32 PM
Dan, I wish I had the AutoCAD expertise to help. Unfortunately, I do not. I suspect that you will end up paying someone to do the work again.

Best of luck finding help.


Yeah....it's looking like that at this point.... :/

<D>
Highrider
02-25-2008, 08:17 PM
The plans look clean. If you find a scanning service close by, you could get each of those prints scanned and converted to Autocad format for about $70 each.
SDGeorge
02-25-2008, 09:41 PM
Hey Dan, I'll check with the guys at work tomorrow. We have a ACAD guru in house that may be able to help you out.
dmulk
02-25-2008, 10:28 PM
Hey Dan, I'll check with the guys at work tomorrow. We have a ACAD guru in house that may be able to help you out.

That would be awesome!!

Thank you very much George!!

<D>
dmulk
02-25-2008, 10:30 PM
The plans look clean. If you find a scanning service close by, you could get each of those prints scanned and converted to Autocad format for about $70 each.

Really? Is this a service someone provides?

Thanks for the input all.
<D>