Silver Bullit
Pearl Black
looking for a quality unit....
90% yes. You have to unplug the speed sensor connector which is located behind the right hand lower section of the tupperware then plug the GIpro back into these 2 connectors. If you do the SpeedoHealer at the same time, then follow the sequence of connector order to plug both into the ST harness. It is tough to get at if you do not remove the plastic on the right hand side. You also have to unbolt the evac canister mounting plates to make the access easier. There are 2 connectors in a plastic sleeve protecting the harness. The one for the speed sensor is the opposite of the GIpro. If the GIpro has black connectors then the ST is the white ones. If the GIpro is white, then the ST ones to unplug are black. What I am saying is there are both a white and black set of connectors in that sleeve. Make sure that you follow the spin the wheel test with the bike on to make sure you have disconnected the speed sensor before continuing the install. Do not ask how I know this .Hi Kenen is this unit a plug and play ..Not great at the electrical end of things....
Glad you got it done. If you got that far, then you should have no problem with the rest.Hi kevin, I did the install of the cluster, ILL be doing the rest of the install tomorrow... thanks...
Does that mean you have it all wired up and have ran it through the gears? If so, great job to you. Always glad to help.I would first like to say that this forum is a great place. The people are fantastic. Kevin the mod came out perfect....I would like to thank you very much for your help....
HelloKevin its all done.ready to roll .Tupper wera is all mounted with some additional heat shielding around the the seat area and i rapped the headers..ready to roll