This is from the 2006 Setup Instructions:
"7. Install the front wheel.
Clean both sides of the front and rear brake
discs with a clean shop towel and Pro Honda
Brake Cleaner or equivalent.
Remove the caliper mounting bolts. Be
careful not to get dust and dirt on the ends of
the mounting bolts.
Support both calipers with a piece of wire,
or similar method, so they do not hang from
the brake hoses. Be careful not to twist the
brake hoses.
Do not operate the brake lever or pedal after
the brake calipers are removed.
Note that the shoulders on each wheel collar
are different sizes. It is important to install
them with the correct sides facing the wheel.
Install the 16.5 mm left-side collar with the
10 mm deep shoulder side facing the wheel.
Install the 27.5 mm right-side collar with the
34 mm outside diameter shoulder facing
the wheel.
Position the front wheel between the
fork legs.
Slide the axle shaft through the left fork leg,
the 16.5 mm left-side collar, front wheel,
27.5 mm right-side collar, and right fork leg.
Push in on the axle shaft so the left end of the
axle shaft is flush with the surface of the left
fork leg.
While holding the axle, install and tighten the
axle bolt to the specified torque.
Torque: 79 N?m (8.1 kgf?m, 58 lbf?ft)
Tighten the right axle pinch bolts to the
specified torque.
Torque: 22 N?m (2.2 kgf?m, 16 lbf?ft).
7. Install the front wheel (cont.).
Reinstall the right and left front brake
calipers, being careful not to damage the
front wheel and related components.
Install the caliper bolts and tighten to the
specified torque.
Torque: 31 N?m (3.2 kgf?m, 23 lbf?ft)
Operate the front brake and pump the forks
several times to seat the axle.
Check the brake operation by applying the
brake lever and pedal.
Check the wheel for free rotation after the
brake is released. If the brake drags or the
wheel does not rotate freely, recheck the
wheel and brake caliper installation.
Visually check the position of the brake disc in
relation to the brake caliper; it should be
centered. If not, recheck the wheel and brake
caliper installation.
7. Install the front wheel (cont.).
Make sure the axle end is flush with the front
fork leg outer surface as shown.
Tighten the left axle pinch bolts to the
specified torque.
Torque: 22 N?m (2.2 kgf?m, 16 lbf?ft)
On the ST1300A, verify the clearance between
the ABS front pulser ring and sensor.
Clearance specification:
0.4 - 1.2 mm (0.02 - 0.05 in)
If outside the clearance specification range,
recheck the wheel installation."