Hi All.
Am in the process of putting the bike back together, after removing all of the Tupperware and chrome for painting, re-chrome,etc. Part of the process has been to remove and powder-coat both left and right lower cowls. The left unit reinstalled very easily, however the right side is presenting more of a problem. Some of the parts were found in a box, and this included the stop-switch cover plate(50618-MCS-G01) and the rubber brake guard (46506-MCS-G00).
Two people have spent the good part of one day trying to figure out the mounting location of the metal stop-switch cover......without luck! I have checked various schematics but these offer little help.
Any advice as to where these are mounted....in relation to the rear brake pedal, would be appreciated.
Regards to all.
Barry
Gardena, CA
Am in the process of putting the bike back together, after removing all of the Tupperware and chrome for painting, re-chrome,etc. Part of the process has been to remove and powder-coat both left and right lower cowls. The left unit reinstalled very easily, however the right side is presenting more of a problem. Some of the parts were found in a box, and this included the stop-switch cover plate(50618-MCS-G01) and the rubber brake guard (46506-MCS-G00).
Two people have spent the good part of one day trying to figure out the mounting location of the metal stop-switch cover......without luck! I have checked various schematics but these offer little help.
Any advice as to where these are mounted....in relation to the rear brake pedal, would be appreciated.
Regards to all.
Barry
Gardena, CA