ChucksKLRST
Team Colorado
- Joined
- Dec 10, 2004
- Messages
- 2,665
- Age
- 74
- Location
- Aurora, Colorado
- Bike
- 2019 Versys 1K SE LT
- STOC #
- 086
Since a lot of us here on the ST forum have defected over to Yamaha FJR's and Super Tee's I thought it would be nice to have our own "What have you done with your Yamaha Today" Thread.
So I will be the first to post what I have done today with my FJR.
Installed dual Horns
Installed AdMore lighting on my Givi V46 Top Box. Running Lights, Turn Signal Lights,and Brake Lights, These are LEDs
Install was relatively easy following ADmore's instructions. Just needed to take ones time when placing the LEDs under the reflectors.
Tapped off the tail light wiring harness that runs along the left side of the bike. Using the SERVICE Manual wiring diagram to determine which wire colors are what, I used the supplied Positaps. Very nice and neat install and can undo in about ten min if ever required. Did not have to cut any wires in the bike harness. Then I uses Gorilla Tape to secure the wires inside the top box.
As a side note: My ADmore lighting kit was missing the positaps. I E-mailed Admore about this. They answered the Email with in a few hours and had the missing parts in the mail with in a day or two. Very good company to work with. I will be purchasing a lighting kit for my Wee STrom Givi E-460 Box later this spring.
So I will be the first to post what I have done today with my FJR.
Installed dual Horns
Installed AdMore lighting on my Givi V46 Top Box. Running Lights, Turn Signal Lights,and Brake Lights, These are LEDs
Install was relatively easy following ADmore's instructions. Just needed to take ones time when placing the LEDs under the reflectors.
Tapped off the tail light wiring harness that runs along the left side of the bike. Using the SERVICE Manual wiring diagram to determine which wire colors are what, I used the supplied Positaps. Very nice and neat install and can undo in about ten min if ever required. Did not have to cut any wires in the bike harness. Then I uses Gorilla Tape to secure the wires inside the top box.
As a side note: My ADmore lighting kit was missing the positaps. I E-mailed Admore about this. They answered the Email with in a few hours and had the missing parts in the mail with in a day or two. Very good company to work with. I will be purchasing a lighting kit for my Wee STrom Givi E-460 Box later this spring.
Last edited: