Ashley
Site Supporter
- Joined
- Aug 16, 2009
- Messages
- 871
- Age
- 61
- Location
- Jacksonville, Florida USA
- Bike
- 2020 Africa Twin
- STOC #
- 4906
So I've had a CCS100 from Murph's Kits for a while now and haven't been brave enough to install it yet. I've read all the info I can find on this forum and others as well as read the install manual. Most installs I've see has involved removing the carbs, or at least lifting high enough, to drill and tap the end of the throttle shaft to attach the bracket to pull the throttle open with. Has any one successfully avoided this and used part 29, throttle wire loop, from the Murph's kit? It is a short bare cable with a loop on one end and a crimp on the other. It's figure 4 in the manual available at http://www.murphskits.com/catalog/docs/cc100_ins.pdf I've had the carbs off before so I'm not unfamiliar with this just trying to find a simpler route.
Edit: Just realized this should be under Cruise Control section. Mods please feel free to move.
Edit: Just realized this should be under Cruise Control section. Mods please feel free to move.
Last edited: