Getting the new trailer all set.
I added a few lights, I wanted these built in so I won't forget anything behind. No muss, no fuss. The beauty of a Roll-A-Home is the less then 2 minute set-up, so I wanted the lights to fit in that game plan too. All runs on 12v battery power. It gets charged via bike connection while riding.
I used 5630 LED strips, cut them to size and then 1" clear heatshrink to attach them to the support poles. Wiring was run through the poles to protect it and again keep it out of the way and undamaged. Grommets installed at each entry and exit point.
6 light option installed:
The sitting room area:
The bedroom:
Bedside reading lamps (switched individually):
Outside night lights for ambiance:
Front porch / security light:
And to control it all (sans bedside lights), a pair of 4 channel RF remotes:
One for me, one for the SO
I added a few lights, I wanted these built in so I won't forget anything behind. No muss, no fuss. The beauty of a Roll-A-Home is the less then 2 minute set-up, so I wanted the lights to fit in that game plan too. All runs on 12v battery power. It gets charged via bike connection while riding.
I used 5630 LED strips, cut them to size and then 1" clear heatshrink to attach them to the support poles. Wiring was run through the poles to protect it and again keep it out of the way and undamaged. Grommets installed at each entry and exit point.
6 light option installed:
The sitting room area:
The bedroom:
Bedside reading lamps (switched individually):
Outside night lights for ambiance:
Front porch / security light:
And to control it all (sans bedside lights), a pair of 4 channel RF remotes:
One for me, one for the SO
Last edited: