I think I already know the first step I need to do is re-bleed. But thought I would also check the collective.
I swapped all fluids on the bike over the weekend. Put a hundred fifty miles on it and it all seems fine till I'm coming home today. When I use the front brake lever, I pull it in a little and barely fell it, then a few seconds later I feel a clunk and then I get more brake response.
Of course this is a little unsettling so I give the system a quick visual and all seems fine so J continue on. It occurs again and I decide to usevthe back brake only.
When I apply that... I hear/feel a chattering. But that stops after a few seconds and beakes act normal. Did it a second time again before I make it to the safety of the garage.
Any thoughts... besides a complete re-bleed. Maybe an air bubble somewhere?
I swapped all fluids on the bike over the weekend. Put a hundred fifty miles on it and it all seems fine till I'm coming home today. When I use the front brake lever, I pull it in a little and barely fell it, then a few seconds later I feel a clunk and then I get more brake response.
Of course this is a little unsettling so I give the system a quick visual and all seems fine so J continue on. It occurs again and I decide to usevthe back brake only.
When I apply that... I hear/feel a chattering. But that stops after a few seconds and beakes act normal. Did it a second time again before I make it to the safety of the garage.
Any thoughts... besides a complete re-bleed. Maybe an air bubble somewhere?