I took the first halting, tentative steps on the install yesterday morning before my day got consumed by other previously-scheduled activities. The wire from the front cam to the back of the bike where the recorder will reside is routed from under the front fairing, through the fork and the mounting points for the right-side fairing, and thence between the cast aluminum frame and airbox before emerging at the seat height and fuel tank position adjustment bracket. This is not necessarily the final route; it was my first guess as to where the best / right route might lie. I ran out of time before I could actually secure the camera under the fairing but it seemed pretty evident that dead center might be a bad idea once I looked at how high the shiny clean chrome sections rise on the forks (suggesting the amount by which the fork compresses and "lifts" the front fender relative to the underside of the fairing).
All I can say so far is that a good stiff fish tape is an asset, if you are working alone. Oh, and it will take more tools than you think to do the job, as it always seems to do.