Here's my version of a bracket mod.
The new brackets push the screen out away from the bike by about 1 inch.
When using the middle angled setting with the lowest height setting,there is 4 inches of space
between the bottom edge of the screen and the Honda emblem.
So there is lots or air flowing under the screen and hitting me in the chest.
There are 6 different height settings and each height has 3 different angles.
I used several pieces of cardboard then masonite before I arrived at the final template. I still had to grind some corners
here and there to get full mobility.
The main tools I used were a grinder with cutting and metal sanding wheel. Drill and drill bits. I bought a 12 x 12 x 1/8 piece of aluminum for
$5.
Todd
The new brackets push the screen out away from the bike by about 1 inch.
When using the middle angled setting with the lowest height setting,there is 4 inches of space
between the bottom edge of the screen and the Honda emblem.
So there is lots or air flowing under the screen and hitting me in the chest.
There are 6 different height settings and each height has 3 different angles.
I used several pieces of cardboard then masonite before I arrived at the final template. I still had to grind some corners
here and there to get full mobility.
The main tools I used were a grinder with cutting and metal sanding wheel. Drill and drill bits. I bought a 12 x 12 x 1/8 piece of aluminum for
$5.
Todd
Attachments
-
117 KB Views: 127
-
144.4 KB Views: 125
-
40.9 KB Views: 52
-
142.6 KB Views: 58
Last edited: