FL-STrider
Roughing it smoothly
- Joined
- Feb 14, 2005
- Messages
- 124
- Age
- 63
- Location
- New Port Richey, Florida
- Bike
- 2004 ST1300
- STOC #
- 5946
The alarm system is orginally supplied with two radio transmitters. In case of loss or failure, ONE or TWO new transmitters can be intialised as follows:
Disarm the system (alarm and immobilizer) via the remaining transmitter (if any) or by entering your personal emergency disarming Confidential Code that was hopefully supplied to you by your dealer or previous owner. (Remark: Honda provides new owners with two small cardboard cards with the emergency code)
Turn the ignition ON, then turn it off and wait about 20 seconds; the dashboard LED illuminates for about 2 seconds. While the LED is illuminated turn the ignition key ON again; the LED extinguishes and the alarm beeps once. You now have 6 seconds at you disposal (*) to press the number 1 button (left button) of the two transmitters in turn; the system beeps to confirm the success of the initialisation operations.
(*) Once the 6 seconds at your disposal have elapsed, the system beeps to warn you that the initialisation period is over.
REMARKS:
1) For security reasons, every system can only accept a maximum of two remote transmitters.
2) Every initialisation procedure disables the transmitters which the receiver had previously "Learned". Therefore if you have lost a transmitter and you wish to initialise a spare one, do not forget to initialise also the one which has remained in your possession (or it will stop working). If you do not wish to initialise the spare one, re-initialise the transmitter which has remained in your hand; so doing you will disable the one you have lost.
Hope this helps
Disarm the system (alarm and immobilizer) via the remaining transmitter (if any) or by entering your personal emergency disarming Confidential Code that was hopefully supplied to you by your dealer or previous owner. (Remark: Honda provides new owners with two small cardboard cards with the emergency code)
Turn the ignition ON, then turn it off and wait about 20 seconds; the dashboard LED illuminates for about 2 seconds. While the LED is illuminated turn the ignition key ON again; the LED extinguishes and the alarm beeps once. You now have 6 seconds at you disposal (*) to press the number 1 button (left button) of the two transmitters in turn; the system beeps to confirm the success of the initialisation operations.
(*) Once the 6 seconds at your disposal have elapsed, the system beeps to warn you that the initialisation period is over.
REMARKS:
1) For security reasons, every system can only accept a maximum of two remote transmitters.
2) Every initialisation procedure disables the transmitters which the receiver had previously "Learned". Therefore if you have lost a transmitter and you wish to initialise a spare one, do not forget to initialise also the one which has remained in your possession (or it will stop working). If you do not wish to initialise the spare one, re-initialise the transmitter which has remained in your hand; so doing you will disable the one you have lost.
Hope this helps