mlheck
Site Supporter
One thing to add here, is if you are going to add a PVC spacer to the stock metal spacer, be sure to put a metal washer between the two. This will make sure that the edge of the stock metal spacer doesn't chew into the PVC, thus contaminating your fork oil. You can also place a washer between the PVC and fork cap to help with the fit. Be sure to add the thickness of the washers to your overall spacer length though.
Actually if you include a couple of washer in your overall spacer length and place them right under the fork caps, you can then add or subtract washer to help dial in your sag. This is much easier than having to pull the plastic spacer and adjust it's length.
Actually if you include a couple of washer in your overall spacer length and place them right under the fork caps, you can then add or subtract washer to help dial in your sag. This is much easier than having to pull the plastic spacer and adjust it's length.
Last edited: