In the process of doing some maintenance and found a leaky fork seal. Took care of that job then noticed that the front pads needed replacing. Got Galfer pads from Bike Bandit. Popped the old pads out and cleaned things up a bit and installed the new ones. Removed some fluid from the master cylinder to allow room for the new pads. Pushed the pistons in as far as they will go but still can't get enough room for the disc to squeeze in. For some reason the inner side of the caliper doesn't seem to want to move to get the needed clearance. Brakes were working fine before the tear down. Was planning on doing a complete bleed once I got things back together. What gives?
Pat
Pat