Hi folks, following on from my post about oil all over the place, I found the offending item which is the rubber seal and or the needle bearing to the gearbox input shaft. I can get to the gear linkage and undone the pinch bolt and just from cleaning out the muck I can see that the rubber seal would most likely come out without to much trouble. So I'm wondering how the needle bearing comes out, wondering if I have to pull the engine out and then take off the rear cover in order to press out the bearing from the inside, any feedback would be of help.
The bearing is #11 on the pic
![bearing.gif](/forums/data/attachments/54/54196-a6e8fef22de6ff3bd15009c8d6a5929c.jpg)
The bearing is #11 on the pic
![bearing.gif](/forums/data/attachments/54/54196-a6e8fef22de6ff3bd15009c8d6a5929c.jpg)