skipcurt
Skip
Hey all, just wanted to throw this out there because I'm having some issues with one or both of these. In the past I've created routes in Tyre and they've worked out very well as long as put extra waypoints in the route to force it to go in a particular direction. So this past weekend I did a 2 day ride using the above method and when I upload the route to the Nuvi the only points in the route are the first and last. Needless to say, this created some serious anxst while on the road. I even created a local route to my buddies house today with 5 waypoints in between the "start" and the "finish" and again the only points showing up are the start and finish. Last year I created about 6 routes for traveling around Colorado while at RockSToc
and a 1500 mile Iron Butt ride and all of these were flawless.
Any ideas? Oh, and by the way this is on a new computer that is running MS Windows 10 but I checked it on the old computer that's running Windows 7 and it's doing it there also. Both 64 bit.
and a 1500 mile Iron Butt ride and all of these were flawless.
Any ideas? Oh, and by the way this is on a new computer that is running MS Windows 10 but I checked it on the old computer that's running Windows 7 and it's doing it there also. Both 64 bit.
Last edited: