Just finished installing a Penske 8983..I mounted the reservoir on the cross-member (drilling 2 tiny holes) using 2 stainless T-Bolt hydraulic hose clamps from Princess Auto. Super simple and worked well. It was a +/- 6mm version. I left it on the low position and dropped the front forks approx 3/16".
Also did a rachtech gold valve kit with new springs too (took the forks into scona cycle to have them install the fork kit and springs) . Looking forward to the twisties out in BC this simmer.
Also made up a backrest bracket from some 1/8 steel..just bolted it onto the front seat...just needs some paint..nice a tidy, the way I like.
Roddy
Also did a rachtech gold valve kit with new springs too (took the forks into scona cycle to have them install the fork kit and springs) . Looking forward to the twisties out in BC this simmer.
Also made up a backrest bracket from some 1/8 steel..just bolted it onto the front seat...just needs some paint..nice a tidy, the way I like.
Roddy