I have a question. To put the headlight globes in, you have to remove and then replace the rubber seal, but I noticed in the photo that the heat vent for the LED globe is sitting outside the rubber seal. Doesn't this mean that there's the possibility of water getting in here and shorting out? Even though the fairing would prevent a lot of water being in that area, isn't the purpose of the rubber seal to act as a barrier to prevent water getting into an electrical item? In this case the connector would have provided the rest of the seal, but here it's plugged into a loom.
So is water getting in here a real risk due to the vents being open to the elements?