Help Identifying a part

I pulled the rear wheel on my and I removed the bolt that has the pin that secures into the yoke. It has a short round boot to keep the grease. When I realized my mistake I looked at a parts guide to make sure everything is where it need to be but I cannot find this part

[FONT=&quot]BOOT, PIN BUSH (NISSIN)[/FONT]
[FONT=&quot]45132-166-016


Can anybody help where to look on my caliper?

Walt[/FONT]

Item 15 on the schematic.

That is a better drawing than the one I pulled up. So just to be sure it slips over the pin on the yoke?

It's installed in the caliper and in turn that slips over the pin on the mounting plate " Yoke ".

Thanks, on the wording it calls it a bushing and I was expecting a metal piece.

That particular boot pushes all the way into the hole so that the end emerges at the other side. So when it is in the caliper, you can see part of the boot emerging at each end.

Double check before inserting it into the hole that you have the opening at the correct side !! The slider pin should be lubricated lightly with silicon grease. Don't use too much as it can create an air lock which can compress and cause the caliper to push the brake pads against the disc rotor - result - hot brakes.