Lifting the '02 ST1100 with a Craftsman MC lift

Joined
Oct 22, 2017
Messages
57
Location
CT
Bike
2002 ST1100
The lift is new and I haven't tried lift the ST1100 with it yet. Do I need to fabricate some kind of a special board so the bike sit's right on the 2 rail that lift the bike?
I have the direction to make a lift base board for the ST1300 but I'm not sure if it will work on the ST1100.
 

kiltman

Site Supporter
Joined
Apr 27, 2013
Messages
3,279
Age
68
Location
Stratford, Ontario Canada
Bike
2002,ST1100ABS
STOC #
8826
Re: Lefting the '02 ST1100 with a Craftsman MC lift

I use a 3/4” thick piece of plywood that measures 12”x24” that sits on the lift. Under the center stand I have a 1”x1”x12” board attached to the plywood and a 2”x4”x5” block that sits under the oil pan by the drain plug and fits between the exhaust pipes. That is what I use on my Bulldog lift which is similar to the craftsman
 
OP
OP
Dan T
Joined
Oct 22, 2017
Messages
57
Location
CT
Bike
2002 ST1100
Re: Lefting the '02 ST1100 with a Craftsman MC lift

Thanks Kiltman. I have a sketch Ken Hill put together for a ST1300 but I don't know if it's good for a ST1100.
 
Top Bottom