What is best to clean old moly off pumpkin
I did mine a couple of days ago. I used contact cleaner and small bits of rags. I cut up small pieces as one wipe and I tossed it into the garbage.
Use latex or equivalent rubber gloves as this is messy.
So, spray a bit of cleaner onto the rag, now using a flat blade screwdriver (or similar tool), stuff the rag in between the gear teeth, rag becomes dirty, toss it and start all over again with a clean rag.
Also, I have heard of people using Q-Tips also.
The only thing I would of liked to do is rotate the gear teeth in the pumpkin. Not sure how to do this with the rear wheel off. I was thinking about making a star like tool, insert it inside the gear teeth to rotate it.
Another way of rotating the pumpkin gear teeth is:
Remove the final drive spline from the rear tire. Insert, the final drive spline into the pumpkin and rotate.
It easier to clean the teeth in the pumpkin if they are near Bottom Dead Center