My first farkle was a riser plate from MCL. The install was easy by following the directions (and not dropping anything down the fairing). Let me know if you have any questions, but I'll just post pictures here. The one thing I did do was to completely remove the loom that goes around the ignition, it made turning the bars easier, which made getting a 14 mm wrench under there easier.
I do have a tight throttle cable, let me know if you have any ideas by replying to that thread.
Before:
Before:
Cover off:
Bars off:
OEM plate off:
MCL Plate on:
Bars on:
Cover on (I didn't wire powerlet yet, but have it in case and it was no extra $):
Done, note the 3 towels protecting the paint on the tank:
I do have a tight throttle cable, let me know if you have any ideas by replying to that thread.
Before:
Before:
Cover off:
Bars off:
OEM plate off:
MCL Plate on:
Bars on:
Cover on (I didn't wire powerlet yet, but have it in case and it was no extra $):
Done, note the 3 towels protecting the paint on the tank: