No start, FI code 13

Joined
Feb 21, 2007
Messages
526
Location
Warrenton, Va
Bike
07 ST1300A
Hopped on ole faithful this am to come to work, and she wouldnt start. FI was throwing a 13 code (long FI light then 3 blinks), look up in the shop manual and it indicated problem with one of the injectors connections - dont recall which one at this time. Anyway, besides possible chaffed wire and dirty/corroded connector, any other suggestions to look for? Will start digging into it tonght. yoohoo :(

(07 ST1300A with 75K miles)
 
OP
OP
gregj
Joined
Feb 21, 2007
Messages
526
Location
Warrenton, Va
Bike
07 ST1300A
Possible, but she doesnt sit long enough for that to happen. Definately hope not.
 
Joined
Mar 21, 2010
Messages
383
Location
N. Ga
Bike
2012 GL1800 III
Prop the tank , pull the air box off. You'll be able to see the actual injector connections . Each on has 2 wires, (white and black if I remember correctly) can only go one 1 way. Check each for corrosion, loose pins, slap some dielectric grease on them, reconnect each at a time and try to restart.

The other end of those wires run to the tail section to the ECM, so look for rubs or wear marks on the wire harness going under the tank back to the tail .

Good luck.
 

wjbertrand

Ventura Highway
Joined
Feb 8, 2005
Messages
4,411
Location
Ventura, CA
Happened to Hal Rumenapp between the time he got home from work one evening and the next morning. The mice had built a whole nest in there in less than 24 hours!
 
OP
OP
gregj
Joined
Feb 21, 2007
Messages
526
Location
Warrenton, Va
Bike
07 ST1300A
I think Bob jinxed me. Pulled her down tonight, little bastage chewed through the #2 and #4 wires. :mad: It had to have done it over night, cause it ran just fine yesterday. I hate mice.

Ah well, I needed to change the air filter anyway.
 

Attachments

Joined
Mar 21, 2010
Messages
383
Location
N. Ga
Bike
2012 GL1800 III
SUB-HARNESS
32103-MCS-770


Liking my shop's natural born killers a little more now ...
 
Last edited:
OP
OP
gregj
Joined
Feb 21, 2007
Messages
526
Location
Warrenton, Va
Bike
07 ST1300A
Thanks Bassplayer.


BTW, if anyone has problems getting the injectors out because the rubber has hardened around them, a MOJO lever works quite well in popping them out. I bent a long tire spoon trying to get it out.
 

SupraSabre

48 Years of SoCal Lane Splitting/Commuting-Retired
Site Supporter
Joined
Nov 20, 2005
Messages
9,511
Location
Cedar City, Utah
Bike
12/04 ST 1300s
2024 Miles
000148
STOC #
5901
I think Bob jinxed me. Pulled her down tonight, little bastage chewed through the #2 and #4 wires. :mad: It had to have done it over night, cause it ran just fine yesterday. I hate mice.

Ah well, I needed to change the air filter anyway.
No jinxing, just have heard of it happening a number of times before! :(
 
OP
OP
gregj
Joined
Feb 21, 2007
Messages
526
Location
Warrenton, Va
Bike
07 ST1300A

Silver Bullet

Retired
Joined
Sep 20, 2009
Messages
629
Location
New London ,Ohio
Bike
2020 Tracer 900 GT
Yea ,the sitting time doesn,t seem like the big deal , but I think the little buggars are going there for the warmth of a recent run and parked machine , hence the quickness of attacking a warm bike ! Hate them little bastages !

MIKE
 
Top Bottom