Installing a Vista CC on ST1300...how???

[AZlouie]

The handlebar bracket on the Vista CC is too wide to fit between the brake assembly and the electronics (starter, kill switch) box on the throttle handlebar. I worked on it for 2 hours with no luck moving the electric box and finally gave up. Has anyone solved this issue???

Many thanks.

Lou

 

[bkra13]

Had the same problem with my ZRX. Took a dremel to the CC, thinned out the portion that was supposed to slide between the grip and control. Worked fine. NExt time I'm going with this tho.

http://www.aerostich.com/go-cruisetm-throttle-control-1.html

 

[v8-7]

Mellow has an install on here somewhere.

It goes between the grip and the electrical box with a small screw drilled into the box to hold it in place .

I think some of the cc bracket is cut off so it is flat.

If you cant find it on here, lmk and I'll get you some pictures .

 

[Byron]

All you have to do is remove the grip and then re-install after you have the Vista in place. I use hairspray to glue the grip back into place and leave it sit over night for things to dry out.

 

[8-BALL]

1 picture =1k words

 

[LegoMan]

Which model Vista CC do you have? A google search revealed a couple of different ones.

I drilled a hole through the bottom of the throttle assembly housing. I used a nylon-stopnut so that I could adjust it and have it stay put. There's a small spacer washer between the Vista Cruise and the throttle body.

 

[AZlouie]

I did it sorta like 8-balls pictures...turned out just fine. There was an issue with the kill switch, but now its OK.
I have the "Universal" model, like in 8-ball's picture...with the arm across the starter housing.

 

[BlackPaw]

I'm experimenting right now with some double sided tape on mine. I need to reposition it since the thumb lever kind of covers the starter switch.