My new shelf

[DarrenJ]

Here it is. Made from checker plate aluminium. Fitted first offer up from the plans on this site. Very sturdy. Next photo shows damage uncovered whilst doing the job. I could replace the centre cowl and also the right side upper fairing for about £150 but I’m not sure if it’s that neccasary. Does that inner cowl offer much protection from weather? Once it’s all buttoned up you can’t see the damage. Any thoughts?

 

[The Dan]

Does that inner cowl offer much protection from weather

Everything is waterproof under there so I wouldn't worry to much. You can smear some silicon behind the cracks to seal it if your worried.

 

[Bikeric]

Just spent 2 hours going through the site looking for a template someone posted to make an aluminium shelf for an ST1100. Does anyone remember this and the link please? I am trying to make up fittings for a Garmin Sat Nav.

 

[Upt' North]

Just spent 2 hours going through the site looking for a template someone posted to make an aluminium shelf for an ST1100. Does anyone remember this and the link please? I am trying to make up fittings for a Garmin Sat Nav.

Eric, any use.
https://www.dropbox.com/s/mp7x9si4jyvysrv/Dashshelf.pdf?dl=0
Hope the link works but must be better info out there, some where.
Upt'North.

 

[DJDixon]

Just spent 2 hours going through the site looking for a template someone posted to make an aluminium shelf for an ST1100. Does anyone remember this and the link please? I am trying to make up fittings for a Garmin Sat Nav.

Try this:

ST1100 Dash Shelf

 

[Upt' North]

mrcom@premier1.net
Apparently this is a bloke who used to make/supply them.
Upt'North.

 

[Bikeric]

Eric, any use.
https://www.dropbox.com/s/mp7x9si4jyvysrv/Dashshelf.pdf?dl=0
Hope the link works but must be better info out there, some where.
Upt'North.

mrcom@premier1.net
Apparently this is a bloke who used to make/supply them.
Upt'North.

Thanks Ray and ST1300A, that is exactly what I was looking for. Spent ages looking and searching, but no luck!! If I can't get anything else, then I will need to get fabricating!!

 

[fnmag]

Thanks Ray and ST1300A, that is exactly what I was looking for. Spent ages looking and searching, but no luck!! If I can't get anything else, then I will need to get fabricating!!

RAY! So that's his name.

 

[Bikeric]

RAY! So that's his name.

Oooooops … that's let the cat out of the bag!!

 

[Upt' North]

I've been called a lot worse on more than one occasion......
Upt'North.