I used 6-inch C-clamps. With very little pressure from the clamps the throttle body popped right up. I braced the clamps with what I had on hand, a 2x4 and a pipe, but a couple of 1x4 boards would probably work out better. The attached photo was taken afterwards but it still shows the position of the clamps.
This was easy and gentle on the throttle body. Oh and took less than five minutes once I found my rusty clamps.
This was easy and gentle on the throttle body. Oh and took less than five minutes once I found my rusty clamps.
Attachments
-
283.2 KB Views: 111