Torque value question

[SuperTanker]

I just did my valve check. Is there a torque value on the two bolts that hold on the coil packs? Also, Those long studs on both sides that are about5-6" long. Do you just snug them all down. If there is a torque value, what page is it on in the Honda book?
thank you
Al

 

[Blrfl]

If there isn't a specific value called out in the service manual, refer to the General Information section at the front of the manual. There's a table of torque specs for bolts that aren't specified.

--Mark

 

[Scooter]

Coil pack bolts are 6mm so the torque on them is 7 ft-lbs (10N-m).

 

[Old2wheeler]

The cylinder head cover "special" bolts are to be tightened STARTING with the TRIANGLE MARKED BOLTS FIRST! (This applies anywhere you see the triangles on the bike.) By the way they are extremely easy to cross thread, so start them very carefully with your fingers only. Once they are all started use a wrench. See P8-34

Rod