3D print files for pre '96 crash-bar covers...

[ST1100Y]

dunno if that's of any interest, currently likely financially more attractive as attempts to import any OEM spares though:

RESTORE YOUR CLASSIC: ST1100 Pan European Crash Pad Cover (older models)

This is a high-precision replacement for the Pan European ST1100 crash pad cover (OEM Part: 64261-MT3-000ZA). Project contains left and right side - this is for older models (like 1993. in 1998 right panel has dent and hole for lock). The design process started with an ultra-accurate 3D scan of...

cults3d.com

 

[jdmccright]

My 1995 had a bike lock loop too, and so does my 2000. Worst case, a little bump-out on the RH would make this work for them.

The model's use is limited to private use. I can't purchase it then sell prints from it. Anyone could buy it and have someone else print it for them. For less than $6, I'd be tempted to just have it on hand.