Been researching posts on here for hours, but can't find anything similar to my situation-
Have the original Honda heated grip acc on my 08, but it stopped working and I found an intermittent high resistance on the throttle side grip.
(wiggling the exposed wire didn't help, pretty sure it's internal to the grip since squeezing and rotating changes the resistance)
The controller seems fine, and I would like to keep it to save installation time/$ if possible.
Was looking at Symtec heaters with the BMW grips as many have used, but it ends up you can get Oxford heated replacement grips (no controller) for $20 each which is cheaper than the former options and a bit easier to install.
Does anyone use Oxfords with the Honda Controller? Assume these would now be wired in parallel.
Which style fits the ST1300 OEM length the best (sport, touring, adv)?
Also, I have the SENA handlebar remote and was wondering if the Oxford's Clutch side wire exit location makes it sit even further from the controls?
TIA!
Have the original Honda heated grip acc on my 08, but it stopped working and I found an intermittent high resistance on the throttle side grip.
(wiggling the exposed wire didn't help, pretty sure it's internal to the grip since squeezing and rotating changes the resistance)
The controller seems fine, and I would like to keep it to save installation time/$ if possible.
Was looking at Symtec heaters with the BMW grips as many have used, but it ends up you can get Oxford heated replacement grips (no controller) for $20 each which is cheaper than the former options and a bit easier to install.
Does anyone use Oxfords with the Honda Controller? Assume these would now be wired in parallel.
Which style fits the ST1300 OEM length the best (sport, touring, adv)?
Also, I have the SENA handlebar remote and was wondering if the Oxford's Clutch side wire exit location makes it sit even further from the controls?
TIA!
Last edited: