I made a thing...

[Jerbear]

I was looking for a suitable place to mount my heated gear controller and came up with this.
Designed in Inventor and printed in industrial 3d Printer.
Very simple pocket that clips into the small access cover on the side panel.
All it takes is a quarter turn to install. I think the pictures are self-explanatory.
I have the .stl file in case anyone wants to print one themselves.
Hope this helps.

 

[Nightmare]

That's pretty nifty! For anyone who doesn't have access to a 3D printer, I got one of those stick on magnets for cellphones, put it on the back on my controller and the magnet holds it on the tank.

 

[Uncle Phil]

That's pretty nifty! For anyone who doesn't have access to a 3D printer, I got one of those stick on magnets for cellphones, put it on the back on my controller and the magnet holds it on the tank.

But the 'tank' on the ST1100 is not magnetic ...

 

[flyfisher]

I sticky taped the velcro stuff to my clutch fluid reservoir....works great and easy to remove and replace

 

[Erdoc48]

Nice job! I have the same Gerbing controller (the original Tourmaster didn’t make the seat pad as warm) and use the plastic Velcro to hold it just below the open panels.