ST1100 "O-Ring" local source?

[ArTravlR]

Time to gather parts for a rear tire replacement and I need three new "O-rings" for the rear wheel. These o-rings are 91358-MG9-003 (50.5X3.5) $12.88, 91356-MG9-003 (39.5X2.4) $2.88, & Honda 91302-MA6-003 - O-Ring (61x2) $4.99. Mike Martins page says the 61X2 o-ring is part # 91304-KT8-003 (61mm x 2mm) http://koczarski.com/mmartin/3rdOring.htm but I can't find that part # on the web. Has anyone sourced these parts locally? TIA

 

[ReSTored]

These are the numbers I used last order from Partsfish

O-RING (39.5X2.4) (ARAI) 91356-MG9-003
O-RING (50.5X3.5) (ARAI) 91358-MG9-003
O-RING (61X2) 91302-MA6-003

So your 61 x 2 PN is correct.

 

[ArTravlR]

Excellent! Thanks for the verification of the part number. Now, I am looking for suitable locally sourced replacement parts. The prices on these three items are all over the place at various OEM internet outlets. Add shipping and sales tax and they approach cost over run. The bike has 169K on it, I'll recycle old parts before dumping over $20 on three simple o-rings.

 

[DeanR]

http://www.carolinabikeandtrike.com/ORings.htm -

15 o-rings (5 complete sets)...$12.99

 

[ArTravlR]

http://www.carolinabikeandtrike.com/ORings.htm -

15 o-rings (5 complete sets)...$12.99

Awesome deal! Thank you so very much. Order has been placed.

 

[Slydynbye]

http://www.carolinabikeandtrike.com/ORings.htm -

15 o-rings (5 complete sets)...$12.99

Just FYI, I got a set of these and have had O-rings failed (broken) when I take the wheels off for new tires.
The stock Honda parts tend to wear down long before breaking.

 

[ArTravlR]

Just FYI, I got a set of these and have had O-rings failed (broken) when I take the wheels off for new tires.
The stock Honda parts tend to wear down long before breaking.

Absolutely! BTDT with OEM O-rings. This will happen if I fail to properly clean the old powered moly grease out of the wheel. I have learned to properly clean the wheel and to replace the rubber wheel dampers & inserts. I'll replace those parts about every 35K, she isn't due for new inserts just yet. Thanks for the warning.

 

[SMSW]

Has anyone sourced these parts locally? TIA

Not exactly local, but you might check this place out for giggles (and o-rings). oringstore.com

I needed some o-rings for an aftermarket gas cap from the other side of the pond. By the time shipping was included, one large o-ring was going to cost me around $20. This oringstore.com sold them to me for something like .40 each. I bought 10 and the first one has lasted 6 months so far.