90210brandon
Be a Zero
This is a duplicate post after receiving confirmation from Mellow that the original was lost in the transition to the new forum layout. So I wanted to share this again with you...
Earlier in the year I pulled the rear end off so I could bring more visibility to the cagers behind me. I pulled off the rear end and started planning the cable routing to bring power to the rear end. This was to add more brake lights (to power LED strips on the panniers). The kit was purchased from Admore Lighting Inc.
Brandon
Earlier in the year I pulled the rear end off so I could bring more visibility to the cagers behind me. I pulled off the rear end and started planning the cable routing to bring power to the rear end. This was to add more brake lights (to power LED strips on the panniers). The kit was purchased from Admore Lighting Inc.
- Photo shows the light strips being tested as they are sitting on the seat of the stripped ST.
- Photo shows the stripped ST and planning the cable routing in the rear of the ST, to light the light strips on the panniers. Note the cables hanging down by the rear tire.
- Next was to mount the LED strips on the bags.
- The pannier is now wired and ready to be put on the bike.
- Photos shows the cables plugged into the panniers.
- Photo showing the finished product.
Brandon
Attachments
-
162 KB Views: 198
-
165.8 KB Views: 200
-
148.8 KB Views: 197
-
91.8 KB Views: 209
-
139.8 KB Views: 225
-
131.2 KB Views: 216
Last edited: