Hi all, I had my side stand off to weld a slightly larger shoe on. The shoe is 6mm thick (bit less than 1/4").
I like the end product. It doubles the original shoe area, is very neat, and makes the ST stand just a little bit higher when on the side stand - good!
One question please: When I replaced the side stand I noticed there is a 'lot' of free play if I push the side stand in towards the bike, and out. (while ST is on the C Stand) I was thinking I may have dropped a shim somewhere. Would a kind ST 'er check the in and out the play of the side stand with ST on C stand?
I would appreciate it.
I like the end product. It doubles the original shoe area, is very neat, and makes the ST stand just a little bit higher when on the side stand - good!
One question please: When I replaced the side stand I noticed there is a 'lot' of free play if I push the side stand in towards the bike, and out. (while ST is on the C Stand) I was thinking I may have dropped a shim somewhere. Would a kind ST 'er check the in and out the play of the side stand with ST on C stand?
I would appreciate it.