- Joined
- Aug 6, 2007
- Messages
- 4,216
- Age
- 49
- Location
- Grant, MN (aka Stillwater)
- Bike
- ST1100 & ST1300
- STOC #
- 6145
I am working on installing a Audiovox CCS100 vacuum cruise for a member here.
The install is pretty much done, I am down to the power connections but have a question. I have read that this cruise will cancel if you hit the cruise or pull clutch. I get where the brake connection comes from. I have made the connection to the brake light circuit with the purple wire. What about the clutch. How does it sense that the clutch has been pulled. In all the directions I have looked at this far there is no mention about tapping into the clutch circuit on the left side of the bike.
From looking at the pinouts on ST Wiki there appears to be two wires that may be used to cancel the cruise. It mentioned the purple wire which I used to brake. Then there is a red wire. Both are coming from the servo unit.
So where does this red wire go?
The install is pretty much done, I am down to the power connections but have a question. I have read that this cruise will cancel if you hit the cruise or pull clutch. I get where the brake connection comes from. I have made the connection to the brake light circuit with the purple wire. What about the clutch. How does it sense that the clutch has been pulled. In all the directions I have looked at this far there is no mention about tapping into the clutch circuit on the left side of the bike.
From looking at the pinouts on ST Wiki there appears to be two wires that may be used to cancel the cruise. It mentioned the purple wire which I used to brake. Then there is a red wire. Both are coming from the servo unit.
So where does this red wire go?