OK!!
Now the bike starts then after 5 seconds dies. I turn the key off and on again and the bikes starts then dies after 5 seconds????
Anyone have a idea???
Larry
It sounds like the mouse chewing on the injector wires is not the problem.
I went back to the first post and you did state which wires had the insulation chewed on. Right side #1 & #3 and you took care of it.....
(I cleaned the nest out and found the 1 and 3 wires to the injectors had been chewed up and I cleaned the wires and recovered them and checked for shorts and have none.)
You also corrected the switched injector wires and it started up.... so if the MAP sensor connector which is grey and the Throttle Position sensor which is blue (and just to the left and rear of the MAP sensor) are correctly hooked up, we are back to the original problem.
NOTE: The MAP & TP sensors share the same wires. The Yellow /Red and the Green/Orange. The third wire for both are Light Green but the MAP sensor wire has a white strip. Easy to confuse them.
The bike is doing the same thing as when you started the post... may be a little different in the backfire not being as bad or worse.
Terry asked..What fault code did you get when you shorted the data plug? Did you clear them before you checked what the fault code was. I did that once but the code came back. I think the bike has to run first for a bit before it will show another code but could be wrong on that.
Could that mouse have chewed through another wire? Don't know if mice have domestic problems but maybe the partner was sent to the rear of the bike and was working on the ECM.
Wish I was more help