I just changed my fork seals on my 2007 ST1300. I have gone through all the articles about setting up the axle and pushing down on the forks to get everything straight.
After putting everything together, the bike still feels like its pointing to the right just a little bit. I almost have to push the handlebars with some force to the left to go straight.
Should i just loosen everything again, and try the straightening routine on the bike. Anyone have suggestion what i can do to make sure i have it lined up straight. Because i can spin the
axle with my finger and thumb and slide side to side with no resistance. Everything is tourque'd correctly, any suggestion would appreciate
Normeyj
Charlotte NC
After putting everything together, the bike still feels like its pointing to the right just a little bit. I almost have to push the handlebars with some force to the left to go straight.
Should i just loosen everything again, and try the straightening routine on the bike. Anyone have suggestion what i can do to make sure i have it lined up straight. Because i can spin the
axle with my finger and thumb and slide side to side with no resistance. Everything is tourque'd correctly, any suggestion would appreciate
Normeyj
Charlotte NC