I picked up a Motion pro tool to try to do a carb sync on my ST1100
Are there any adaptors i need to get before starting this project .
I have read some posts that mention getting a "tee" so you can keep the fuel valve operating .
I believe the size mentioned was 5 mm ??????
Do i need any other connectors ?
Do the hoses on the tester slide onto fittings on the bike , or connect to other hoses, meaning if would need some type of straight coupling connector .
I'm also trying to find a link to one resource that might have directions (with pictures !!! ) on how to do this procedure .
The ST1100 is new to me , only have it a month or so . (been riding 30 years)
I looked in the owners manual , it refers you to the service manual .
I bought a service manual (Honda) as i do for all my bikes , and it give a little info , then refers you the the Honda "Common Service Manual " ?????
Wasn't planning on buying that one unless i have to .
thanks in advance for any and all help
Joe
Are there any adaptors i need to get before starting this project .
I have read some posts that mention getting a "tee" so you can keep the fuel valve operating .
I believe the size mentioned was 5 mm ??????
Do i need any other connectors ?
Do the hoses on the tester slide onto fittings on the bike , or connect to other hoses, meaning if would need some type of straight coupling connector .
I'm also trying to find a link to one resource that might have directions (with pictures !!! ) on how to do this procedure .
The ST1100 is new to me , only have it a month or so . (been riding 30 years)
I looked in the owners manual , it refers you to the service manual .
I bought a service manual (Honda) as i do for all my bikes , and it give a little info , then refers you the the Honda "Common Service Manual " ?????
Wasn't planning on buying that one unless i have to .
thanks in advance for any and all help
Joe