In doing my 88k valve check I found 3 of the 4 exhaust on the right side below spec. Following Marks wonderful pictorial I opted to release the tension on the chain by not pulling the throttle bodies. A much more friendly and less time consuming alternative I thought. If only I was so talented.
Instead of getting the crush washer on the chain tension cover off nice and neatly trapped on the end of my screw.. it disappeared into the abyss.
The local shops are not stocking them... a generic 6mmm crush washer.
NAPA may or may not have one.
So will any 6mm aluminum washer work? Say like a backing plate for an aluminum pop-rivet?
Instead of getting the crush washer on the chain tension cover off nice and neatly trapped on the end of my screw.. it disappeared into the abyss.
The local shops are not stocking them... a generic 6mmm crush washer.
NAPA may or may not have one.
So will any 6mm aluminum washer work? Say like a backing plate for an aluminum pop-rivet?