Delkevics - clamps

[VetteJim]

Got my Delkevic mufflers last week and they are very nice. However the clamps are too small for attaching to the stock headers. I reused the stock clamp on one side but the other one was corroded and broke. I emailed Delkevic about it but haven't heard anything yet (and no phone number for them!). Anyways the parts diagram on partzilla.com shows two different part numbers for them which is strange. Would have thought they were the same size. I'll see if I get a reply from Delkevic and I would like to use their clamps because they are very nice, otherwise I will get either the Honda ones or some aftermarket clamps.

 

[Obo]

I used these T bolt clamps from Amazon. 1.75" when my OEM's broke.

 

[Hound]

I've used Mikalor/Ticon stainless clamps which have been fine. The ones Obo posted look fancier, though.

 

[Obo]

Would have thought they were the same size.

OEM's are the same size, but they are left and right because of the flanges on them. That way it also puts the bolt heads to the rear.

 

[VetteJim]

OEM's are the same size, but they are left and right because of the flanges on them. That way it also puts the bolt heads to the rear.

Ah - ok, I was wondering why they were different part numbers. Makes sense since they have notches in them for locating.