The temps were in the 90's today with the dew point at 76. Muggy and hot to ride a motorcycle for sure. Finally I had a chance to try out my most recent effort to mitigate the heat problem down to a tolerable level. I am not saying ALL the heat is gone or solved. My efforts just helped reduce the amount of direct hot air coming up around the tank directly into my crotch. My Corbin seat stayed much cooler for a lot longer. This past week I covered the bottom of my seat with the mylar insulation someone had suggested on this forum. I believe the largest improvement gained was installing the piece of foam pipe insulation around the back of the tank where the seat meets up with the tank. The amount of air coming up in front of the seat is now minimal. I am pleased that at least it takes a good while before the bike would become uncomfortable. I drove 100 miles today for a trial run to see. I found a definite improvement at least for me. The cost was hardly enough to mention being 20 bucks or less.