First I hope this is the proper place to post this to... (if not Mod/Admin please move thread to correct forum)
There is a very small pull distance needed to fully engage my front brakes (it's a pretty hard pull right off the bat not like it starts soft then get's harder as you pull in more).
I put the bike on the center stand and spun the wheel. You can audibly hear the pads lightly rubbing against the disc and see that there isn't free travel of the wheel.
My question to the community is why would this be happening? (I've been looking for a while online and can't find anything)
Any help appreciated
Other info...
2000 Honda ST1100
The front pads have plenty of life left
Fluid levels are good and there doesn't appear to be air in the system
There is a very small pull distance needed to fully engage my front brakes (it's a pretty hard pull right off the bat not like it starts soft then get's harder as you pull in more).
I put the bike on the center stand and spun the wheel. You can audibly hear the pads lightly rubbing against the disc and see that there isn't free travel of the wheel.
My question to the community is why would this be happening? (I've been looking for a while online and can't find anything)
Any help appreciated
Other info...
2000 Honda ST1100
The front pads have plenty of life left
Fluid levels are good and there doesn't appear to be air in the system