But were they spectacular??
On my ST1300, equipped with a MotorcleLarry bar riser, the Suzuki handguards blocked vision in the upper inboard corners of my mirrors. But that space is still used because I stuck a couple small rectangular convex (wide angle) mirrors in those corners with double-back tape. Turned out to be a win-win situation.I find that the guards obscure my mirrors too much to tolerate.
Filed a bit of material so the tubes will no longer interfere.I've been wanting to do this mod, but after looking at the front brake lever pivot bolt location I find that the throttle cable tubes sit right above the pivot bolt. How have people been dealing with the interference of the throttle cables?
Those sure look like they'll block the mirrors for sure. They look nice though!I ordered a set of Barkbusters Blizzard guards. I will post pic's after I install them.
Is there a better link?Check this LINK to MY-MC for a nice write up of these hand guards installed on an 1100.