Sadlsor
Site Supporter
- Joined
- Jan 15, 2020
- Messages
- 4,284
- Age
- 66
- Location
- Birmingham, Alabama
- Bike
- 2008 ST1300A
- STOC #
- 9065
I'm going to install my Garmin XT in the 2-wire quartet harness connector, and before I run my Warm n Safe to the battery, I'm wondering whether I can power the WnS jacket liner and gloves (with a dual Heat Troller) from one of the other connectors there?
Should be a 9- and 4-pin, if I recall. One was originally for the factory Honda heated grips; could I wire a Hitachi connector to that one, ya think?
I may add lights later, and another USB charger outlet, but any further farkles will go to a separate fuse box, not installed at this time.
The XT gps will be easy enough... what are your thoughts on the gloves and jacket liner?
Battery, or q-harness? Connecting the WnS gear to the Honda harness will negate the need for a separate relay (which I'll add later to the fuse block), I'm thinking.
(I've looked through 8 or 10 ST1300 Articles on fuse blocks, the harness, electric clothes, and all, but didn't find anything to specifically answer this question.
Thanking y'all too very much.
Should be a 9- and 4-pin, if I recall. One was originally for the factory Honda heated grips; could I wire a Hitachi connector to that one, ya think?
I may add lights later, and another USB charger outlet, but any further farkles will go to a separate fuse box, not installed at this time.
The XT gps will be easy enough... what are your thoughts on the gloves and jacket liner?
Battery, or q-harness? Connecting the WnS gear to the Honda harness will negate the need for a separate relay (which I'll add later to the fuse block), I'm thinking.
(I've looked through 8 or 10 ST1300 Articles on fuse blocks, the harness, electric clothes, and all, but didn't find anything to specifically answer this question.
Thanking y'all too very much.