Help! I need help wiring ST1300 for a trailer

[Imrubicon]

I purchased a Uni-GO Trailer and I have the wired in for the brake and right turn signal. tail light wire is in but a bad connection for the tail light(I will work on that) bad crimp?.
But where do you find enough wire to splice to for the right turn signsl ?
Do I have to take the whole tail light assembly apart ?
I can get the buld out but the wire is so short I can work a tap in there.
Pictures would help those of us that are challenged in the first place

I would be grateful for any help

Thanks in advance
Mike

 

[dannyk]

I just wired up a set of hyperlight turn signals on mine, removed the rear seat/smuggler in my case, and un plugged the tab from the rear of the turn signal bulb housing, this gave me some slack to work the posi taps with, I also, on one side had to strip back a little bit of the protective tube to make it work. Took less than 20 minutes to complete the project. :biker:

 

[Imrubicon]

Any pictures as I am trying to find posi taps today .

 

[Imrubicon]

So much for that as I must have backed over a screw and it is embedded in my rear tire dead center . All were accounted for but somehow one found its sneaky way into my tire . I am on hold till weds as the shop is closed Mon and tues I need to call for a appointment.
So a bump to the top for this topic