I carry a jump starter as many of us do now. I am not having any trouble but if one had total battery failure could the battery be removed and the jump starter as the battery be used to get home or to a new battery?
Dave.David said:It would be better that once the bike is running to put the battery back on and ride home keeping the idle above 1500.
Having said that, if your bike is running properly, it should run with NO battery or jumper attached, once started... If it doesn't, then you need to look to the charging system vs. the battery as your issue, IMHO.
Quick question on a related topic, we have an MT07 that won't start, battery is showing 12.5 volts, so it's charged fully I think, turn the bike on, it primes sometimes but there is no crank, just a clicking noise from somewhere under the seat near the battery, is the battery dead? or is it some other simple issue, bike was running fine before, last ran the engine about 6 weeks ago.
I carry a jump starter as many of us do now. I am not having any trouble but if one had total battery failure could the battery be removed and the jump starter as the battery be used to get home or to a new battery?
Quick question on a related topic, we have an MT07 that won't start, battery is showing 12.5 volts, so it's charged fully I think, turn the bike on, it primes sometimes but there is no crank, just a clicking noise from somewhere under the seat near the battery, is the battery dead? or is it some other simple issue, bike was running fine before, last ran the engine about 6 weeks ago.
If you hear the relay clicking, then its likely that the handlebar switch is OK, its only job for the starting circuit is to energize the relay. One failure mode could be the relay itself is bad across the high current switch bar. Another failure mode could be excess resistance somewhere in the path from the battery to the starter relay, or starter relay to the starter motor. The high current draw from the starter motor will cause large voltage drops across any small resistance in the path. Once the voltage drop goes beyond a certain point, the motor won't turn. Corroded wires/connectors are the most likely culprit, unless the relay has somehow self destructed.anyway connected the bikes battery leads to my jeep with jumper cables, same as before, bikes dash is lighting up, but it will bot crank over when pressing the starter, just that clicking noise from under the seat same as before, so I think it must be the handlebar starter switch that's the issue, or I've read it could be the starter relay wherever that is,