I recently ordered and received this rack for my ST1100A:
A forum member who owns this rack (kiltman) suggested, based on his experience with a cracked bolt, that I measure the gap between the head of the supplied bolts and the tailpiece and compare it with the thickness of the rack. I did that and there was enough of clearance, even more when you add the washers of course.
I was prepared to do some hammering if things didn't quite line up, but it lined up perfectly.
So it was just a simple matter of installing the bolts and washers and voilà!
The rack is solid and looks good also.
A forum member who owns this rack (kiltman) suggested, based on his experience with a cracked bolt, that I measure the gap between the head of the supplied bolts and the tailpiece and compare it with the thickness of the rack. I did that and there was enough of clearance, even more when you add the washers of course.
I was prepared to do some hammering if things didn't quite line up, but it lined up perfectly.
So it was just a simple matter of installing the bolts and washers and voilà!
The rack is solid and looks good also.